![]() IF you pulled that out the track would drop 1/8" unlocking the tongue and groove (that is on top of the track, and the underside of the housing embedded in the concrete that the track goes in) and allow you to pull the track out, also exposing the hidden chamber where the rope runs. The wheels are held onto the cart by a nut and bolt. With its wheels, this assembly connects to the slider to stabilize it to the track. There is a little thin grey piece of plastic that you see under the track. Coverstar 805 Top-Track Wheel Cart Assembly with Inserts for 3' Leading Edge Bar (Set of 2) This Coverstar Top-Track Wheel Cart Assembly is simple and easy to replace on to your Top-Track Cover. He also explained to me the "tongue and groove" method in which the tracks are held in the pool wall. In my case he is going to adjust one of the ropes (meaning re-wrap it around the cylinder either shorter or longer). He said that having the torque limiter set too weak might cause it not to pull the cover tight against the pool and close the gap (if a pool was out of square). He believes they still stretch a tiny bit. Regarding the cover (in closed position) not being closed equally on each side he said that these new style black ropes are supposed to be non-stretch. ![]() He said that after the newness wears off sometimes this adjustment is required (he did say had he done the entire install it would have been more "dialed in"). ![]() He tighten those a couple of turns (which supply's more torque to the motor) the stuttering went away. The torque limiter looks like a disc brake on the end of the motor. My cover was stuttering upon closing and difficult to open, the problem was the torque limiter. You can also spray the food grade silicon down the entire track. Pulleys can be greased, he suggests food grade spray silicon. Mine is the new style and has no grease points, bearings all sealed/self lubed. He explained everything to me, and I understand what was going on. This was the one that installed the initial tracks and pit who i liked and enjoyed talking to. Okay so the installer followed through and called me.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |